Carbide 3D Shapeoko 4 XXL, Инструкция по сборке

Страница: 32 / 43

S T E P 8
S T E P 8 – H y b r i d T a b l e
60 docs.carbide3d.com support@carbide3d.com 61
8.2 Install Hybrid Extrusions
1. Position the ten (10) hybrid extrusions, from
front to back. See Fig. 8-2 .
2. Use a 4mm hex key and eight (8) M6×10mm
FHS to secure each hybrid extrusion to the
baseframe.
a. Insert screws in order: front, back, center.
b. Loosely insert all screws in an extrusion
before fully tightening.
Figure 8-2 Figure 8-3
8.3 Install MDF Strips
1. Position the ten (10) MDF strips inside the
hybrid extrusions. See Fig. 8-3 .
2. Use a 5mm hex key and four (4) M6×20mm
SHCS to secure each MDF strip. Fully tighten.
a. Insert screws in order: front, back, center.
NOTE: We do not recommend using power tools
here; the risk of cross-threading is too high.