Carbide 3D Shapeoko 4 XXL, Инструкция по сборке

Страница: 13 / 43

S T E P 4
S T E P 4 – E n d p l a t e s
22 docs.carbide3d.com support@carbide3d.com 23
4.3 Install Back‑Right
Endplate
1. Positi on the back-right endplate at the back
end of the Y-Right rail. See Fig. 4-4 .
a. Proximity switch to outside/front.
b. Be careful not to pinch the Y-Axis proximity
cable between the endplate and drag
chain support panel or the end of the rail.
Figure 4-4
4.4 Install Y‑Left Endplates
1. Position the two remaining endplates at either
end of the Y-Left rail. See Fig. 4-5 .
a. Curved flange on the lower part of the
endplate goes to INSIDE.
b. Tapered corners to the outside/top.
2. Use a 4mm hex key and four (4) M6×12mm
BHCS to secure each endplate to the rail. Fully
tighten.
Figure 4-5
2. Use a 4mm hex key and four (4) M6×12mm
BHCS to secure the endplate to the rail. Fully
tighten.