Canon CXDI-31, Руководство по обслуживанию

Страница: 55 / 209

2 Installation Manual
- 29 -
4.3.4. Installing A/D Board Exposure Code
(1) Purpose
To write exposure code into the Flash ROM of the A/D board.
(2) Notes
Be sure to check the following items before installing the exposure code:
1 CXDI application software is installed.
2 A/D board Boot Code is installed.
3 CXDI is connected to build up the system.
(3) Procedure
1) Open the left side cover of the control PC unit.
2) Turn on the power of the whole CXDI system. Then, start Windows NT.
3) Insert <A/D Board Exposure Code> floppy disk into the control PC’s floppy drive.
4) Click the Start button, point to Programs, and then click Command Prompt.
5) C:\> prompt appears. After C:\>, type the commands following the instruction below:
Type d: and press [ENTER] key.
Type cd ccr and press [ENTER] key. ( indicates space)
Type the number of the sensor to which you wish to write.
Type capload /s 1 to input to sensor 1.
Type capload /s 2 to input to sensor 2.
Do not press the [Enter] key here.
6) Open Windows NT Explorer at this stage in step 5). (It is better if the window is not set
to full-screen display.)
Start Æ Programs Æ Windows NT Explorer
7) A file named “****.mot” is contained in 3½ Floppy (A:). Drag and drop this file to copy
it to capload /s 1, and then press the [Enter] key after selecting the Command Prompt
screen.
* Display on the Command Prompt screen
d:\ccr>capload \s 1 a:\****.mot
Å Displayed as the full path.