Cabletron Systems SSIM-A2-01, Инструкция по установке и эксплуатации

Страница: 78 / 88

69
SmartStack SSIM-A2-01/SSIM-A8-01
65 Bearer capability not implemented
73 Unsupported combination of traffic parameters
78 AAL parameters cannot be supported
81 Invalid call reference value
82 Identified channel does not exist
88 Incompatible destination
89 Invalid endpoint reference
91 Invalid transit network selection
92 Too many pending add parties requests
93 AAL parameters cannot be supported
96 Mandatory information element is missing
97 Message type non-existent or not implemented
99 Information element non-existent or not implemented
100 Invalid information element contents
101 Message not compatible with call state
102 Recovery on timer expiry
104 Incorrect message length
111 Protocol error, unspecified
0202 Virtual connection Bind failed Code : <xx>
The requested virtual connection on the ATM Uplink could not be established. The
following error codes are defined:
1. The VCI -VPI number is outside the range of the Uplink.
Change switch configuration.
4. All supported connections are in use.
Change configuration in the configuration file.
0203 Virtual connection Parameters Unsupported Code: <xx>
The parameters received from the network for an incoming connection cannot be
set in the Uplink.
Action: Contact technical support.
0204 Outg. call rejected by remote party: <Called ATM
address><Location Code>:<Cause Code>
An outgoing call has been rejected by the called device. Location Code is always 0
(remote party).
The cause code indicates why the call was rejected, see table for ‘0201’
0205 Outg. call rejected by remote party: <Called ATM
address><Location Code>:<Cause Code>
As for '0204', but the '0205' message only occurs for cause 21 and 31, which can
occur during normal network operation.