Cabletron Systems SSIM-A2-01, Инструкция по установке и эксплуатации

Страница: 17 / 88

8
SmartStack SSIM-A2-01/SSIM-A8-01 Installation
Hardware Installation
Use the following steps to install the SSIM-Ax-01 module in a STS16-20RM
Token Ring Switch:
1. Power off the base switch by unplugging the power cord from the power outlet.
If the switch uses the optional SmartStack STS-PSU Redundant Power Supply
Unit, unplug the connector from the base switch as well.
2. Select an empty expansion module slot in which to install the module. You can
install the module in either or both of the slots.
3. Remove the blind plate covering the expansion module slot on the front of the
STS16-20RM by loosening the two retaining thumbscrews (Figure 5). Keep the
plate for use in the event that the expansion module is removed.
Figure 5. Removing the Expansion Slot Cover
➽
Warning: Expansion modules are not hot-swappable. If you install or remove
expansion modules while the power to the switch is on, damage may occur to the
switch and to the module.
4. Carefully insert the module into the rails on each side of the expansion slot,
sliding it back until the connector on the module is seated into the connector at
the back of the slot (Figure 6). When the module is fully seated, the module
faceplate will be flush with the front of the base switch.
Figure 6. Installing the SSIM-Ax-01 Module
5. Secure the module with the two attached thumbscrews.
6. Reapply power to the switch.