Bull Novascale Blade BL465, Инструкция по установке и эксплуатации, Страница: 84 / 128

70
novascale Blade BL465 - Installation and User's Guide
The POST event log contains the three most recent error codes and messages that were
generated during POST.
The system-event log contains POST and system management interrupt (SMI) events
and all events that are generated by the baseboard management controller that is
embedded in the integrated management module.
mportant
If the system-error LED on the front of the server is lit but there are no other error
indications, clear the system-event log. Also, after you complete a repair or correct an
error, clear the system-event log to turn off the system-error LED on the front of the server
− POST Event Viewer
Select this choice to enter the POST event viewer to view the POST error
messages.
−
System Event Log
Select this choice to view the system event log.
− Clear System Event log
Select this choice to clear the system event log.
•
User Security
Select this choice to set, change, or clear passwords.
You can set, change, and delete a power-on password and an administrator password
through this selection. If you set a power-on password, you must type the power-on
password to complete the system startup and to have access to the Setup Utility menu.
The password must be from 6 to 20 characters. You can use any combination of ASCII
printable characters for the password. Keep a record of your password in a secure
place.
If you forget the power-on password, you can regain access to the blade server either
by removing the blade server battery and then reinstalling it or by using the power-on
password override switch (see the
Problem Determination and Service Guide
for
instructions).
An administrator password is intended to be used by a system administrator; it limits
access to the full Setup utility menu.
WARNING
If you set an administrator password and then forget it, there is no way to change,
override, or remove it. You must replace the system board.
• Save settings
Select this choice to save the changes that you have made in the settings.
•
Restore Settings
Select this choice to cancel the changes that you have made in the settings and restore
the previous settings.