Bull Novascale Blade BL465, Инструкция по установке и эксплуатации, Страница: 68 / 128

54
novascale Blade BL465 - Installation and User's Guide
b. Align and place the heat sink on top of the microprocessor in the retention
bracket, thermal material side down. Press firmly on the heat sink.
c. Align the screws on the heat sink with the holes on the heat-sink retention module.
d. Press firmly on the captive screws and tighten them with a screwdriver, alternating
among the screws until they are tight. If possible, each screw should be rotated
two full rotations at a time. Repeat until the screws are tight. Do not overtighten
the screws by using excessive force. If you are using a torque wrench, tighten the
screws to 1.13 ± 0.13 Newton-meters (Nm) (10 ± 0.15 in-lbs).
12. Make sure that, at a minimum, memory modules are installed in DIMM connectors 1
and 4. See Installing a DIMM on page 34 for more information on installing a memory
module.
13. Install the access panel if you removed it earlier.
Figure 3-24. Installing the access panel
a. Make sure that the screws on the access panel are in the open position (the screw
insert is parallel to the side of the access panel).
b. Slide the back of the cover under the blade server bezel, aligning the screws with
the slots on the blade server.
c. Using a screwdriver or a coin, turn each of the screws away from the middle of
the blade server until it is in the locked position.