Bull Novascale Blade BL465, Инструкция по установке и эксплуатации, Страница: 77 / 128

Chapter 3. Installing Options
63
Notes 1. When any blade server or option is in any blade bays 7 through 14,
power modules must be present in all four power-module bays. For
additional information, see the Installation and User’s Guide that comes
with the Blade Chassis.
2. If you are reinstalling a blade server that you removed, you must install it
in the same blade bay from which you removed it. Some blade server
configuration information and update options are established according
to blade server bay number. Reinstalling a blade server into a different
blade server bay number from the one which it was removed can have
unintended consequences, and you might have to reconfigure the blade
server
.
3. To maintain proper cooling, do not operate a Blade Chassis without a
blade server, expansion unit, or blade filler in each blade bay.
3. Make sure that the release handles on the blade server are in the open position
(perpendicular to the blade server).
4. Slide the blade server into the blade bay until it stops.
5. Push the release handles on the front of the blade server to the closed position.
Note After the blade server is installed, the IMM in the blade server initializes and
synchronizes with the management module. This process takes
approximately two minutes to complete. The power-on LED flashes rapidly,
and the power-control button on the blade server does not respond until this
process is complete
6. Turn on the blade server (see Turning on the blade server on page 15 for instructions).
7. Make sure that the power-on LED on the blade server control panel is lit continuously,
indicating that the blade server is receiving power and is turned on.
8. If you have other blade servers to install, do so now.
If this is the initial installation for the blade server in the Blade Chassis, you must configure
the blade server through the Setup Utility and install the blade server operating system. See
Updating the blade server configuration on page 64, and Chapter 5, Installing the
operating system , on page 97 for details.
If you have changed the configuration of the blade server or if you are installing a different
blade server from the one that you removed, you must configure the blade server through
the Setup Utility, and you might have to install the blade server operating system. For more
information, see Using the Setup Utility on page 66 .