Bull Novascale Blade BL465, Инструкция по установке и эксплуатации, Страница: 52 / 128

38
novascale Blade BL465 - Installation and User's Guide
3.12 Installing a hypervisor key
Use these instructions to install a hypervisor key in the blade server.
If you are using the BL465 blade server in a virtualized environment, you might have to
install a hypervisor key, depending on the virtualization software that you are using. If you
are using a BL465 complex that is configured as a single hardware partition, install the
hypervisor key in the bottom (left) blade server in the BL465 complex.
If the blade servers in a BL465 complex are operating independently, you might have to
install a hypervisor key in each blade. To determine whether you need a hypervisor key,
see the documentation that comes with your virtualization software.
The following illustration shows the installation of the hypervisor key.
Figure 3-12. Installing a hypervisor key
To install a hypervisor key, complete the following steps:
1. Before you begin, read the safety information that begins on page vii and Installation
guidelines on page 23.
2. If the blade server is installed in a Blade Chassis, remove it (see Removing the blade
server from the Blade Chassis on page 25 for instructions).
3. Carefully lay the blade server on a flat, static-protective surface.
4. Open the blade server cover (see Removing the blade server cover on page 26 for
instructions).