Bull Novascale Blade BL465, Инструкция по установке и эксплуатации, Страница: 108 / 128

94
novascale Blade BL465 - Installation and User's Guide
21. Restart the blade server (see Turning off the blade server on page 16 and Turning on
the blade server on page 15). The system begins the power-on self-test (POST). If this
does not recover the primary bank continue with the following steps.
22. Remove the blade server form the Blade Chassis (see Removing the blade server from
the Blade Chassis on page 25).
23. Remove the server cover. See Removing the blade server cover on page 26.
24. Reset the CMOS by removing the battery (see Removing the battery in section 5.9 of
the Problem Determination and Solving Guide ).
25. Leave the battery out of the server for 5 minutes.
26. Reinstall the battery (see Installing the battery in section 5.9 of the Problem
Determination and Solving Guide ).
27. Replace the cover and reinstall the blade server in the Blade Chassis, making sure that
the media tray is selected by the relevant blade server. See Installing the blade server
cover on page 60 and Installing the blade server in a Blade Chassis on page 62.
28. Restart the blade server (see Turning on the blade server on page 15).
The system begins the power-on self-test (POST).
4.8.3 In-band automated boot recovery method
Download the server UEFI firmware update package and complete the following steps.
Note Use this method if the SYS BRD LED on the light path diagnostics panel is lit and there is an
AMM event log entry or Booting Backup Image is displayed on the firmware splash screen;
otherwise, use the in-band manual recovery method.
1. Download the blade server UEFI firmware update from the Bull support web site (see
Updating firmware and device drivers on page 78).
2. Boot the server to an operating system that is supported by the firmware update
package that you downloaded (see Turning on the blade server on page 15).
3. Perform the firmware update by following the instructions that are in the firmware
update package readme file.
4. Restart the server (see Turning off the blade server on page 16 and Turning on the
blade server on page 15).
5. At the firmware splash screen, press F3 when prompted to restore to the primary bank.
The server boots from the primary bank.