Bull Novascale Blade BL465, Инструкция по установке и эксплуатации, Страница: 51 / 128

Chapter 3. Installing Options
37
3.11 Removing a DIMM
Use this information to remove a dual inline memory module (DIMM) from the blade server.
The following illustration shows how to remove a DIMM from the blade server.
Figure 3-11. Removing a DIMM
To remove a DIMM, complete the following steps:
1. Read the safety information that begins on page vii and Installation guidelines on
page 23.
2. If the blade server is installed in a Blade Chassis, remove it (see Removing the blade
server from the Blade Chassis on page 25).
3. Open the blade server cover (see Removing the blade server cover on page 26).
4. Locate the DIMM connectors (see Blade server connectors on page 21).
Determine which DIMM you want to remove from the blade server.
Attention: To avoid breaking the retaining clips or damaging the DIMM connectors,
handle the clips gently.
5. Make sure that both retaining clips on DIMM connector from which you will be
removing the DIMM are in open position.
6. Using your fingers, pull the DIMM out of the connector.