Bull Novascale Blade BL465, Инструкция по установке и эксплуатации, Страница: 54 / 128

40
novascale Blade BL465 - Installation and User's Guide
9. Install the hypervisor adapter:
a.
Orient the connector on the hypervisor interposer with the interposer connector on
the system board, aligning the pins on the side of the hypervisor interposer with
the pinholes on the interposer connector (see “Blade server connectors” on page
20).
b. Use your fingers to push the adapter into the connector on the blade server.
Attention: Be careful not to damage the pins on the hypervisor interposer.
10. Install the access panel:
Figure 3-14. Installing the access panel
a. Make sure that the screws on the access panel are in the open position (the screw
insert is parallel to the side of the access panel).
b. Slide the back of the cover under the blade server bezel, aligning the screws with
the slots on the blade server.
c. Using a screwdriver or a coin, turn each of the screws away from the middle of
the blade server until it is in the locked position.