Brocade Communications Systems Network Advisor 12.3.0, Руководство пользователя

Страница: 863 / 1940

Brocade Network Advisor SAN User Manual 811
53-1003154-01
Configuring encryption storage targets
20
Failback option
The Failback option determines the behavior when a failed encryption engine is restarted. When
the first encryption engine comes back online, the encryption group’s failback setting (auto or
manual) determines how the encryption engine resumes encrypting and decrypting traffic to its
encryption targets.
•
In auto mode, when the first encryption engine restarts, it automatically resumes encrypting
and decrypting traffic to its encryption targets.
•
In manual mode, the second encryption engine continues handling the traffic until you
manually invoke failback using the CLI or the Management application, or until the second
encryption engine fails. When the encryption engine recovers, it can automatically fail back its
CryptoTarget containers if the second encryption engine is not hosting them.
Invoking failback
To invoke failback to the restarted encryption engine from the Management application, complete
the following steps:
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
dialog box. (Refer to Figure 266 on page 694.)
2. Select an encryption group from the Encryption Center Devices table to which the encryption
engine belongs, then click Group > HA Clusters.
The Encryption Group Properties dialog box displays, with the HA Clusters tab selected (Refer
to
Figure 366 .)
3. Select the online encryption engine, then click Failback.
4. Click OK, then close the Encryption Center dialog box.
Configuring encryption storage targets
Adding an encryption target maps storage devices and hosts to virtual targets and virtual initiators
within the encryption switch. The storage encryption wizard enables you to configure encryption for
a storage device (target).
NOTE
It is recommended that you configure the host and target in the same zone before configuring them
for encryption. If the host and target are not already in the same zone, you can still configure them
for encryption, but you will need to configure them in the same zone before you can commit the
changes. If you attempt to close the Encryption Targets dialog box without committing the changes,
you are reminded of uncommitted changes in the Management application.
The wizard steps are as follows:
1. Select Encryption Engine
2. Select Target
3. Select Hosts
4. Name Container