Brocade Communications Systems Network Advisor 12.3.0, Руководство пользователя

Страница: 1015 / 1940

Brocade Network Advisor SAN User Manual 963
53-1003154-01
Adding an FCIP circuit
22
2. Select Cross port circuit to configure the 10 GigE port on an 8 Gbps Blade platform as a 10
Gbps lossless failover circuit.
3. Select the IP Address Type. The implementation is a dual IP layer operation implementation as
described in RFC 4213. IPv6 addresses can exist with IPv4 addresses on the same interface,
but the FCIP circuits must be configured as IPv6 to IPv6 and IPv4 to IPv4 connections.
IPv6-to-IPv4 connections are not supported. Likewise, encapsulation of IPv4 in IPv6 and IPv6
in IPv4 is not supported.
4. Select the IP Address for each port. This implementation of IPv6 uses unicast addresses for
the interfaces with FCIP circuits. The unicast address must follow the RFC 4291 IPv6 standard
and use the IANA-assigned IPv6 Global Unicast address space (2000::/3).
NOTE
For the Brocade 7840, you can configure two IP addresses, one as primary in the Connectivity
group and the other as secondary in the HA Connectivity group. The primary address is
mandatory.
5. For IPv4 addresses, specify the Subnet Mask. For IPv6 addresses, specify the prefix length.
The default is created from the IP address and Subnet Mask. If you want to create a route
through a gateway router, click Create Non-Default Route, and select a Gateway address.
6. Enter the MTU Size.
For SAN traffic, the largest possible Maximum Transmission Unit (MTU) size is generally the
most efficient. Enter a value from 1260 through 2348 for the 4 Gbps platforms and from 1260
through 1500 for the 8 Gbps platforms. MTU rates must match on both ends of the tunnel.
NOTE
For the Brocade 7840, MTU size ranges from 1236 through 9216.
If you have an active connection between switch one and switch two, click Verfiy IP
Connectivity under Switch One Settings to test the connection. To determine a suggested size,
packets are sent across the FCIP tunnel, starting at the largest possible size packet that can
be sent over IP. If a valid connection response is not received, a smaller packet is sent. This
continues until a valid connection response is received, and that size becomes the suggested
MTU size. MTU settings must match at both ends of the tunnel, and the setting specified under
Switch One Settings is automatically applied to switch two.
NOTE
The function of the Verify IP Connectivity button function requires an active IP connection. The
button is not available for the Add FCIP Circuit and Edit FCIP Circuit dialog boxes for 8 Gbps
Extension platforms.
NOTE
Verify IP Connectivity button is not supported on Brocade 7840.
7. If a VLAN ID is used to route frames between the switches over the physical connection, enter
the VLAN ID under Switch One Settings. You must assign the same VLAN ID to both the
switches. If the VLAN ID is not same, an error message displays.
The VLAN ID is an integer value from 1 through 4094 which sets the VLAN tag value in the
header, assigning the traffic to that specific VLAN. Layer 2 class of service (L2CoS) values may
be assigned to establish traffic priorities over a VLAN.