Brocade Communications Systems Network Advisor 12.3.0, Руководство пользователя

Страница: 1317 / 1940

Brocade Network Advisor SAN User Manual 1265
53-1003154-01
SNMP traps
32
FIGURE 540
Add Trap Destination dialog box
4. Enter a general description of the trap destination in the Description field.
5. Enter the IP address of the trap destination in the IP Address field. This is a mandatory field.
IPv4 and IPv6 addresses are accepted, but a DNS name is not accepted.
6. Enter the SNMP trap listening port of the recipient in the Port # field. This is a mandatory field.
Valid numeric values range from 1 through 65535.
The Enable check box, Add Source Address check box, and SNMP Trap Repeater check box are
selected by default. When selected, all traps, whether the source is managed or unmanaged,
are forwarded. When unselected, only traps from the selected products are forwarded. When
selected, the Open View Source Name is added to the variable binding (varbind) value to the
trap before forwarding.
7. Select a supported SNMP type from the Trap Forwarding Type list. Supported SNMP types are
v1, v2c, and v3. The default SNMP type is v1.
8. You can choose not to select a filter (zero), or you can select up to five filters from the Available
Filters list. Click the right arrow button to move them to the Selected Filters list.
9. Click OK.
Adding a new trap filter
The Add Trap Filter dialog box allows you to configure trap filters for forwarding SNMP traps. You
can add trap filters on SAN products, IP products, or hosts. These filters can be on individual
switches or the Fabric as a whole.
To add a new trap filter, complete the following steps.
1. Select Monitor > SNMP Setup > Trap Forwarding.
The SNMP Trap Forwarding dialog box displays.
2. Click Add in the Trap Filters area of the SNMP Trap Forwarding dialog box.
The Add Trap Filter dialog box, shown in Figure 541 , displays.