Brocade Communications Systems Network Advisor 12.3.0, Руководство пользователя

Страница: 1013 / 1940

Brocade Network Advisor SAN User Manual 961
53-1003154-01
Configuring an FCIP tunnel
22
-
Select L2CoS and DSCP priorities. Refer to “QOS, DSCP, and VLANs” on page 946 for more
information.
-
Select OK to save the settings and close the dialog box.
5. To edit the configuration for an existing FCIP tunnel and circuits between two switches, follow
these steps:
a. From the FCIP Tunnels dialog box (refer to step 1 ), select the FCIP tunnel that you want to
configure under the Products tree.
b. Click Edit
The Edit FCIP Tunnel dialog box displays. This dialog box allows you to edit configurations
on both switches on either end of the tunnel.
A Circuits properties table displays at the bottom of the dialog box. For 8 Gbps platforms,
this may contain columns for multiple circuits. Actual as well as cached circuits display.
You can configure circuits using the Add, Edit, Delete, Enable, and Disable buttons to the
right of the table. For 4 Gbps platforms, the Delete, Enable, and Disable buttons do not
display. In addition, the Edit operation is only supported for cached circuits.
c. Change configuration settings as required using the following steps.
6. To add a circuit, click Add to the right of the Circuits properties table at the bottom of the dialog
box.
The Add FCIP Circuit dialog box is displayed. Continue with “Adding an FCIP circuit” .
Logical switch function on the FCIP Tunnels dialog box
The display and function of tunnels and circuits created on logical switches and with shared GigE
ports varies on the FCIP Tunnels dialog box according to the discovery of the default switch and
user-configured logical switches as follows:
•
If the default and user-configured logical switches are discovered, all tunnels and circuits
created on the logical switch display, including circuits with shared GigE ports.
•
If the user-configured logical switch is discovered and the default logical switch is not
discovered, the circuits and tunnels with shared GigE ports will be listed in the tunnel, but they
cannot be edited or deleted.
•
In a fabric with two logical switches that have a shared GigE port and only the default logical
switch for one logical switch is discovered, the circuits and tunnels with shared GigE ports will
be listed in the tunnel, but they cannot be edited or deleted.
For details on configuring FCIP with logical switches, use the following references:
•
“Using FCIP with logical switches” section in the Fabric OS FCIP Administrator’s Guide .
•
Chapter 19, “Virtual Fabrics” .