Page 45
Sonic-Pro
Industries, Ltd.
Industries, Ltd.
ProSeries
by Blue-White Ind.
TM
6.3.3
Metering
Setup
The
Metering Setup
branch of the
Configuration Edit Menu
allows you to
select how the flowmeter will display, record
and otherwise process flow measurements,
including the units of measure, averaging,
frequency of update, scaling at signal
outputs and logging.
Changes in this area of configuration affect
only the way in which the flowmeter
presents flow information on the display, at
output signals and in logging. This will not
ENTER
Ç
ESC
È
Configuration Set #3
Ê
Flow Rate
Ê
Volume Units
Acre Feet
Ê
Ounces
U.S. Barrels Liquid
U.S. Barrels Oil
Cubic Feet
Metering Setup
U.S. Gallons
ENTER
Ç
ESC
È
Configuration Set #3
Ê
Metering Setup
Totalizer
Signal Output
Data Logging
Display
Flow Rate
cause the flowmeter to make incorrect flow measurements.
Under the
Metering Setup
branch, the following actions are available:
Flow Rate --> Volume Units
allows you to
specify the units of measure in which flow
rates are displayed and written to log
entries.
can also select
Custom Volume
Units
in the list and use the
Flow Rate -->
Custom Volume Unit
per U.S. Gallon to
enter the equivalent of one U.S. Gallon in
that unit. This alternative should be used if
the desired unit of measure is not in the list
offered.
Flow Rate --> Time Units
allows
to
select the time part of the units of measure
You
you
for flow rates. The options available are seconds, minutes, hours and days.
Flow Rate --> Digits After Decimal Point
allows
to specify how many digits appear
after the decimal point when flow rate is displayed on the Run Mode screen.
you
Flow Total --> Volume Units
allows
to
specify the units of measure in which flow
totals are displayed and written to log
entries. This is independent of the units of
measure for flow rates, so that the flow rate
units of measure mey be different than the
flow total units. As for
Flow Rate
, a custom
unit of measure can be specified.
Flow Total --> Digits After Decimal Point
allows
to specify how many digits
appear after the decimal point when flow
total is displayed on the Run Mode screen.
you
you
ENTER
Ç
ESC
È
Configuration Set #3
Ê
Metering Setup
Volume Units
Total Display Function
Digits After Decimal Point
Totalizer
Ê
Flow Total --> Total Display Function
allows
to enable or disable the clearing of the
recorded total flow using the
CLEAR
soft button on the display in
Run Mode
and also
the clearing of batch counts and totals on
Process Control Screens
.
you
