79
By using
Copy by Activation
, the sensor ID that is retrieved from activated sensor is
programmed to the new MX-Sensor.
Because the IDs of the original sensor and the new MX-Sensor are the same and the ID
is already recognized to the vehicle ECU, there is no need to perform the
Relearn
function when the new programmed sensor has been attached to the same wheel.
If the IDs retrieved from sensor activation and those registered to the TPMS ECU are
different, use
Copy by OBD
to program the IDs saved in the ECU to the new MX-Sensor.
Copy by OBD
By using this function, the tablet will program the sensor IDs retrieved from the ECU of
the test vehicle to the new MX-Sensors.
Select a wheel location on the display and place a MX-Sensor near the top right corner
of the tablet. Tap
Copy by OBD
to program the new MX-Sensor.
When the programming is complete, the programmed ID will display in the column to the
right of the wheel designation. In the pictured example, the new ID is displayed to the
right of the FR column.
By using
Copy by OBD
, the sensor ID that is retrieved from TPMS ECU is programmed
to the new MX-Sensor.
There is no need to perform the
Relearn
function to write the ID into the ECU when the
new programmed sensor has been put in the same position.
The
Copy by OBD
programming method, if available, is recommended to program new
MX-Sensors as there is no need for Relearn.
Copy by Input
The
Copy by Input
allows users to program a new MX-Sensor with the ID of an original
TPMS sensor.
Figure 6-21
Sample Copy by OBD Screen
