50
3) The following screen will display a message to advise that the fault memory of the
parking brake control unit will be deleted. Press
Continue
to proceed or the
Back
button on the bottom navigation bar to exit.
4) Follow the on-screen instructions to pull the parking brake button and wait for
approximately three seconds until the parking brake is set. When the operation is
successfully completed, a “Completed successfully” message will display on the
screen, press
OK
to exit.
Parking Brake: Workshop Mode
This service is used to activate and deactivate the so-called installation position for the
Automatic Hold brake. In this mode the parking brake is moved into the opened position
and temporarily deactivated for personal protection.
The installation position must be activated for the following repairs:
Replacement of brake pads.
Replacement of a brake caliper.
Replacement of an actuator.
Select
Parking Brake: Workshop Mode
and follow the on-screen instructions to
perform a series of operations to start the brake pad after replacement.
When the operation is successfully completed, a “Completed successfully” message will
appear on the screen. Press
OK
to exit.
Battery Management System (BMS) Service
The Battery Management System (BMS) allows the scan tool to evaluate the battery
charge state, monitor the close-circuit current, register the battery replacement, and
activate the rest state of the vehicle.
NOTE
1. This function is not supported by all vehicles. The screens shown in this section are
examples.
2. The sub functions and actual test screens of the BMS vary by vehicle, please follow
Figure 5-8
Sample EMF Start-up Screen 3
