AudioCodes Mediant 4000 SBC, Руководство пользователя

Страница: 56 / 1037

CHAPTER 6 Web-Based Management
Mediant 4000 SBC | User's Manual
Depending on the access level (e.g., Monitor level) of your Web user account, certain
pages may not be accessible or may be read-only (see
Configuring Management User
Accounts ). For read-only privileges:
● Read-only pages with stand-alone parameters: "Read Only Mode" is displayed at
the bottom of the page.
● Read-only pages with tables: Configuration buttons (e.g., New and Edit ) are
missing.
Configuring Stand-alone Parameters
Parameters that are not contained in a table are referred to as stand-alone parameters.
■ If you change the value of a parameter (before clicking Apply ), the parameter's field is
highlighted, as shown in the example below:
■ If you change the value of a parameter from its default value and then click Apply , a dot
appears next to the parameter's field, as shown in the example below:
■ If you change the value of a parameter that is displayed with a lightning-bolt icon (as shown in
the example below), you must save your settings to flash memory with a device reset for your
changes to take effect. When you change such a parameter and then click
Apply , the Reset
button on the toolbar is encircled by a red border. If you click the button, the Maintenance
Actions page opens, which provides commands for doing this (see
Basic Maintenance ).
■ Typically required parameters are displayed in bold font.
■ If you enter an invalid value for a parameter and then click Apply , a message box appears
notifying you of the invalid value. Click OK to close the message. The parameter reverts to its
previous value and the field is surrounded by a colored border, as shown in the figure below:
■ To get help on a parameter, simply hover your mouse over the parameter's field and a pop-up
help appears, displaying a brief description of the parameter.
The following procedure describes how to configure stand-alone parameters.
➢
To configure a stand-alone parameter:
1. Modify the parameter's value as desired.
2. Click Apply ; the changes are saved to the device's volatile memory (RAM).
3. Save the changes to the device's non-volatile memory (flash):
● If a device reset is not required:
i. On the toolbar, click Save ; a confirmation message box appears:
- 23 -