ATS Maximus MCJ2000 Series, Справочное руководство

Страница: 123 / 214

Chapter 4: Color Terminals Initial Setup
MANU-MAXIMUS-02 Maximus Reference Manual 4-7
Revision-02
Static IP / Dynamic DHCP
This parameter enables you to switch the IP mode of the Maximus terminal. When set to
Static IP , the IP address of the terminal is fixed. Use the IP Address parameter to set a static IP
address for the terminal (described in the following section). When set to Dynamic DHCP , the
IP address of the terminal is determined by the DHCP server on the local network. The IP
address of the terminal might change periodically, based on what the DHCP server assigns.
Use the “F2” key to toggle between Static IP and Dynamic DHCP . If you set the terminal to
Static IP the Initial Setup menu displays the IP Address parameter that enables you to set the
static IP address for the Maximus (described in the following section).
IP Address
The Initial Setup menu displays this parameter when set to Static IP (not available when set to
Dynamic DHCP ). It enables you to set a Static IP for the terminal (clock). If displayed, press the
“F3” key to select the IP Address parameter. The screen prompts you to enter an IP address
for the clock (terminal) as shown in Figure 4-5 .
Figure 4-5 Clock (Terminal) IP Address Prompt (Initial Setup)
Re-Boot
Press the “F4” key to select the Re-Boot parameter. The system will prompt you to confirm as
shown in Figure 4-6 .
03:38:15
Friday
Nov 7, 2014
Enter the Clock
TCP/IP Address:
_ _ _ . _ _ _ . _ _ _ . _ _ _
Make sure you do not use the same IP address more than once on the network, as doing so
can result in communication conflicts.
NOTE: