ATS Maximus MCJ2000 Series, Справочное руководство

Страница: 106 / 214

3-52 Maximus Reference Manual MANU-MAXIMUS-02
Revision-02
Test Mode Chapter 3: Monochrome Terminals
2. Press the enter key to initiate the test. The terminal illuminates all the LEDs on
the terminal then briefly shuts them all off. When the test is complete the
“power LED” returns to the normal illuminated state (and any others if
applicable). You can now press the
enter key to run the test again or press the
clear key to exit the LED test and return to the Test Mode menu.
Display Test
The display test cycles the all the pixels on the LCD display on and off so you can confirm they
are working. Use the following procedure to run the display test:
1. In the Test Mode menu, press the clear key until the Display Test option
appears.
2. Press the enter key to initiate the test. The terminal illuminates all the pixels on
the LCD then briefly shuts them all off. When the test is complete the LCD
returns to the
Test Mode , Display Test option. You can now press the enter
key to run the test again or press the clear key to exit the display test and return
to the Test Mode menu.
Speaker/Beep Test
The speaker/beep test sends three increasing frequency tone signals to the speaker to ensure it
is working properly. Use the following procedure to run the speaker/beep test:
1. In the Test Mode menu, press the clear key until the Speaker/Beep Test
option appears.
2. Press the enter key to initiate the test. The terminal sends three increasing
frequency tone signals to the speaker. You can now press the enter key to run
the test again or press the clear key to exit the speaker/beep test and return to
the Test Mode menu.
Test Mode
Display Test
Test Mode
Speaker/Beep Test