ATS Maximus MCJ2000 Series, Справочное руководство

Страница: 149 / 214

Chapter 4: Color Terminals Test Mode
MANU-MAXIMUS-02 Maximus Reference Manual 4-33
Revision-02
System Test
This does a quick check on the integrity of the RAM, FLASH, and EEPROM installed on the
terminal. Press the
enter key when the display reads “ Test Mode System Test ” to enter the
test and display the “ System Test Press Enter to Test ” prompt. The results of the test appear
on the screen when the test completes, including notification of any failures. Press the enter
key when the system displays “
Enter to continue ” to exit the test.
Speaker/Beep Test
Press the enter key when the display reads “ Test Mode Speaker/Beep Test ” to start the
test. The terminal initiates three increasing frequency beeps to verify that the speaker works
correctly. Press the
clear key or select either Prev or Next to exit the test.
Display Test
Press the enter key when the display reads “ Test Mode Display Test ” to start the test. The
display turns all the pixels off then on. Press the clear key or select either Prev or Next when
finished.
LED Test
Press the enter key when the display reads “ Test Mode LED Test ” to start the test. This lights
all the LEDs on the terminal one at a time, including those behind the lens and those on the
keypad. Press the
clear key or select either Prev or Next when finished.
Serial Test: Printer
This test is a loopback and reserved for service personnel. It tests the auxiliary port and requires
a specific hardware jumper.
Serial Test: Direct
This test is a loopback and reserved for service personnel. It tests the serial port and requires a
specific hardware jumper.
System Diag Dump
This is a test done under the direction of a service technician to help troubleshoot the terminal.
This test saves the results of your tests to a text file on a USB flash drive installed in the
Maximus USB port.
Press the
enter key when the display reads “ Test Mode System Diag Dump ” to start. When
the system displays the “ Attach USB Drive then press Enter ” prompt, open the Maximus
cover and insert a USB flash drive into the USB port then press the enter key. The system
displays “
Results copied to USB ” when complete. You can review the results with the
technician by opening the text file (on a PC). Press the clear key or select either Prev or Next
when finished.
Exit
Press the enter key when the display reads “ Test Mode Exit ” to exit to the Test, Setup,
Diagnostics menu (see "Test, Setup, Diagnostics (TSD) Menu" on page 4-13 ).