ATS Maximus MCJ2000 Series, Справочное руководство

Страница: 62 / 214

3-8 Maximus Reference Manual MANU-MAXIMUS-02
Revision-02
Initial Setup Chapter 3: Monochrome Terminals
3. Next the terminal displays the default/saved addressing mode for the terminal.
The default value is
Dynamic DHCP . In DHCP mode the terminal receives its IP
address from the connected DHCP server (therefore the terminal IP address may
periodically change).
Press the enter key to accept DHCP mode and continue or press the clear key
to toggle the display between the Static IP and Dynamic DHCP selections.
If the terminal was already in the displayed mode ( Dynamic DHCP or Static IP )
and you pressed the enter key without changing it, the terminal enters the ATS
TSD Mode . Proceed to "ATS TSD Mode" on page 3-13 ).
• The Static IP selection enables you to set the terminal to a permanent IP
address.
• When the terminal displays the desired option ( Dynamic DHCP or Static
IP ) press the enter key to save the selection and continue to the next
parameter.
• If you changed to the Static IP option the terminal displays the static IP
addressing parameters starting with Setup Clock IP .
• If the terminal is set to Static IP (and rebooted) the terminal displays Static
IP for the Type .
You can access the static IP parameters by pressing the clear key, toggling
the Static IP and Dynamic DHCP options and re-saving the Static IP
option.
4. The Setup Clock IP parameter enables you to change the static IP address for
the terminal. Press the clear key then use the numeric keys to change the
terminal IP address. Press the enter key to save the new address and continue.
If you type an invalid IP address, the terminal displays Bad IP Address .
Press the clear key again, correct the IP address then press the enter key to
continue.
Setup Addressing
Type: Dynamic DHCP
Setup Clock IP
000.000.000.000