ASTRO WM-3209, Инструкция по эксплуатации, Страница: 24 / 254

12
(3) Connecting a Remote Controller
When Using a Contact Power Supply System
Check that the POWER switch on the unit is OFF and connect the remote controller to REMOTE
((11) on the rear panel) of the WM-3209/WM-3209-L.
Confirm the shape of connectors before use.
When Using an External ID Display (WM-3209/WM-3209-L Only)
Check that the POWER switch on the unit is OFF and connect the remote controller to RS485
((12) on the rear panel) of the WM-3209/WM-3209-L.
Confirm the shape of connectors before use.
3.2 Method of Operation
A protective film is attached to the surface of the liquid crystal panel at time of shipment. Remove the
protective film before using the WM-3209/WM-3209-L
Check connections and then turn ON the power of the WM-3209/WM-3209-L using the POWER switch
on the front panel. The POWER LED will light and an image will be displayed.
If the POWER LED does not light, check connections again.
Use MONITOR OUT for easy verification of the SDI input signal.
If there is no input signal, the imaging area will appear black and the indicator No Signal will be
displayed in red.
If no signals are input for LinkB of the dual link signals or there is a difference between the LinkA and
LinkB phases,
PhaseError is displayed in red on the screen.
When Dual Link has been selected as the input channel, a phase
difference equivalent to ±15 clock pulses between the LinkA signals and
LinkB signals is absorbed. If the LinkB signals are not input or the phase
difference cannot be fully absorbed,
PhaseError is displayed at
the bottom of the screen.
CAUTION
When Dual Link has been selected as the input channel, a phase difference
equivalent to ±15 clock pulses between the LinkA signals and LinkB signals is
absorbed. If the LinkB signals are not input or the phase difference cannot be
fully absorbed,
PhaseError is displayed at the bottom of the screen.
CAUTION