Arkray SPOTCHEM EZ SP-4430, Руководство по эксплуатации

Страница: 84 / 139

C SP-4430 ● 3-13
Chapter 3 SUB MENU
Set parameters (measurement conditions) for temperature, coefficient
of correlation correction, normal value range, and calibration
conditions. Regarding Multi-type Reagent Strips, setting of “calibration
conditions” only is possible. The other parameters conform to those
preset for Single Reagent Strips.
■
Temperature
This device consistently performs measurements under the condition of measurement
of 37 ℃ . It can also convert the measurement results to those measured at 30 ℃ or
25
℃
and output the converted results. However, only enzyme values can be
converted.
■
Coefficient of correlation correction
This function allows your results obtained by this device to match the results by another
measurement method (reference method). Apply the regression equation Y = aX + b (X:
measurement result of the SP-4430, Y: the result obtained by the reference method.)
Enter coefficient values for a and b. For obtaining the coefficients of correlation
correction for a and b, contact your distributor.
■
Standard range
When the measurement results are printed, “ ▲ ” or “ ▼ ”, is added on data out of the
standard range.
When sample type is set, its corresponding standard range is applied.
■
Calibration Conditions
Set the type (calibrator or magnetic card) and the number of times of calibration for
each measurement item.
1-4
装置の設置
3-3-2 Enter parameters
If [STOP] key is pressed during
entry, the entry is canceled and
the cursor returns to the
previous “[ ]” or “< >”.
If the previous setting is not
necessary to change, press
[ENTER] key to proceed to next
“[ ]” or “< >”.
▲▲
Display setting screen. 1.
Press [2] key on the MAIN MENU.
SUB MENU 1/2 is displayed.
Press [2] key. The PARAMETER
MENU 1/2 is displayed.
Press [2] key and the Password
entering screen is displayed.
Enter password “99”.
Press [ENTER] key.
The Measurement item selecting
screen is displayed.
●
●
●
●
［ Sー０１：G G T ］
（ １／３０ ）
１ . R e s u l t s ２ . P A R AM
３ . M a i n t e n a n c e
（ １／２ ）
１ . M e a s u r e ２ . S u b m e n u
３ . C a l i b r a t e
（ １／１ ）
１ . P r i n t ２ . I n p u t
３ . I n i t i a l y z e （ １／２ ）
P a s s w o r d ＜ ＞
C a n c e l（ S T O P ）
▲ mark is not printed when the
upper limit of the standard
range is the same or higher
than the upper limit of the
measurement range.
▼ mark is not printed when the
lower limit of the standard
range is the same or lower than
the lower limit of the
measurement range.
▲