Arctic Cat WILDCAT/X, Руководство по обслуживанию

Страница: 125 / 187

123
1. Battery voltage with engine and accessories off
(>12.2 VDC for fully charged).
2. Battery voltage with engine running (charging = 13.8
VDC or greater).
3. Battery voltage with electrical accessories operating,
engine idling (13.5 VDC or greater).
4. Battery voltage starter cranking (10.5-11.5 VDC).
DIAGNOSTIC TROUBLE CODES
(DTC)
If an EFI or related chassis component fails or an out-of-
tolerance signal is detected by the ECM, a diagnostic trou-
ble code (DTC) will be generated in the ECM and dis-
played on the LCD. The DTC will continue to flash until
the malfunction is corrected and the code cleared.
Code List

NOTE: Each of the following numerical codes will
have a one-letter prefix of C, P, or U. A “C” prefix
denotes a chassis malfunction, a “P” prefix
denotes a power train malfunction, and a “U” pre-
fix denotes a loss of communication with the
gauge.

NOTE: Normal malfunction codes are cleared from
the LCD when the component is replaced or the mal-
function is corrected; however, intermittent codes
must be cleared as noted in the code chart.
Code Fault Description Possible Cause Fault Recovery
C0063 Tilt Sensor Circuit High Sensor or interconnect harness shorted to battery power Correct condition*
C0064 Tilt Sensor Circuit Low/SG/Open Sensor or interconnect harness open or shorted to chassis ground Correct condition*
C1263 Backup/Reverse-Light Circuit Open Bulb has failed or is disconnected or interconnect harness is open Correct condition*
C1264 Backup/Reverse-Light Circuit High Bulb has failed or is disconnected or interconnect harness shorted
to battery power Correct condition*
C1265 Backup/Reverse-Light Circuit Low/SG Bulb has failed or is disconnected or interconnect harness shorted
to chassis ground Correct condition*
P0030 O2 Heater Intermittent/Open Heater or interconnect harness is intermittent or open Correct condition*
P0031 O2 Heater Low/SG Heater or interconnect harness shorted to chassis ground Correct condition*
P0032 O2 Heater High/SP Heater or interconnect harness shorted to battery power Correct condition*
P0107 MAP Sensor Circuit Low/SG/Open Sensor or interconnect harness shorted to chassis ground Correct condition*
P0108 MAP Sensor Circuit High/SP Sensor or interconnect harness shorted to battery power Correct condition*
P0112 Intake Air Temp Sensor Circuit Low/SG Sensor or interconnect harness shorted to chassis ground Correct condition*
P0113 Intake Air Temp Sensor Circuit High/Open Sensor or interconnect harness open or shorted to battery power Correct condition*
P0114 Intake Air Temp Sensor Circuit Intermittent Sensor or interconnect harness intermittent Correct condition*
P0116 ECT Sensor Circuit Range/Performance Sensor producing an out-of-range voltage Correct condition*
P0117 ECT Sensor Circuit Low/SG Sensor or interconnect harness shorted to chassis ground Correct condition*
P0118 ECT Sensor Circuit High/Open/SP Sensor or interconnect harness open or shorted to battery power Correct condition*
P0119 ECT Sensor Circuit Intermittent Sensor or interconnect harness intermittent Correct condition*
P0121 TPS Range/Performance Sensor producing an out-of-range voltage Correct condition*
P0122 TPS Circuit Low/SG Sensor or interconnect harness shorted to chassis ground Correct condition*
P0123 TPS Circuit High Sensor or interconnect harness open or shorted to battery power Correct condition*
P0130 O2 Sensor Intermittent/Open Sensor or interconnect harness intermittent or open Correct condition*
P0131 O2 Sensor Low/SG or Air-Leak Sensor or interconnect harness shorted to chassis ground or an air-
leak exists Correct condition*
P0132 O2 Sensor High/SP Sensor or interconnect harness shorted to battery power Correct condition*
P0171 O2 Feedback Below Minimum Correction Low fuel rail pressure, dirty fuel filter, or dirty injectors Correct condition*
P0172 O2 Feedback Exceeds Maximum Correction Excessive fuel rail pressure, MAP or temp sensors out-of-spec Correct condition*
P0219 Engine Over-Speed Condition Engine speed (RPM) has exceeded the ECM over-speed setpoint/
limit Reduce engine speed
P0231 Fuel Pump Relay Circuit Low/SG/Open Relay removed or interconnect harness shorted to chassis ground Correct condition*
P0232 Fuel Pump Relay Circuit High Relay or interconnect harness shorted to battery power Correct condition*
P0233 Fuel Pump Relay Circuit Relay circuit erratic or intermittent Correct condition*
P0261 Cylinder #1 Fuel injector Circuit Low/SG Injector #1 or interconnect harness shorted to chassis ground Correct condition**
P0262 Cylinder #1 Fuel injector Circuit High Injector #1 or interconnect harness shorted to battery power Correct condition**
P0263 Cylinder #1 Fuel injector Balance/Open Injector #1 disconnected or interconnect harness is open Correct condition**
P0264 Cylinder #2 Fuel injector Circuit Low/SG Injector #2 or interconnect harness shorted to chassis ground Correct condition**
P0265 Cylinder #2 Fuel injector Circuit High Injector #2 or interconnect harness shorted to battery power Correct condition**
P0266 Cylinder #2 Fuel injector Balance/Open Injector #2 disconnected or interconnect harness is open Correct condition**
P0336 Crankshaft Angle Sensor Synchronization Sensor or interconnect harness intermittent Correct condition**
P0337 Crankshaft Angle Sensor Circuit/SG Sensor or interconnect harness shorted to chassis ground Correct condition**
P0339 Crankshaft Angle Sensor Intermittent/Erratic Sensor or interconnect harness intermittent Correct condition**
P0340 Camshaft Angle Sensor Synchronization Sensor or interconnect harness intermittent Correct condition**
P0341 Camshaft Angle Sensor Circuit/SG Sensor or interconnect harness shorted to chassis ground Correct condition**
P0342 Camshaft Angle Sensor Intermittent/Erratic Sensor or interconnect harness intermittent Correct condition**
P0480 Fan Relay Control Circuit Relay erratic or intermittent Correct condition*
P0484 Fan Relay Control Circuit High Relay or interconnect harness shorted to battery power Correct condition*