Setup
Page 23 of 178
background of the associated row.
Figure 3.5. - Successful IP address assignment
It is possible to force the module back into DHCP mode by powering up the device with DIP
switch 2 set to the On position. A new IP address can then be assigned by repeating the
previous steps.
NOTE:
It is important to return DIP switch 2 back to Off position, to avoid the
module returning to a DHCP mode after the power is cycled again.
If the module’s DIP switch
2 is in the On position during the address assignment, the user will
be warned by the following message.
Figure 3.6. - Force DHCP warning
In addition to the setting the IP address, a number of other network parameters can be set
during the DHCP process. These settings can be viewed and edited in Slate
’s Application
Settings, in the DHCP Server tab. Once the DHCP process has been completed, the network
settings can be set using the Ethernet Port Configuration via the Target Browser. The Target
Browser can be accessed under the Tools menu.
Figure 3.7. - Selecting the Target Browser
