Ametek IPS-4-UV, Руководство пользователя

Страница: 53 / 200

Installation & Start-Up | 3-23
7. View the current output ranges. To do this:
a. Press the
SETUP
soft key to view the SETUP menu screen. Scroll
down to select Current Outputs and press
ENTER
to display the
Current Outputs 1 thru 4 screen. Scroll down to select Current
Outputs 1 screen (Figure 3-6).
Figure 3-6.
Current Output Setup
screen (Current Out 1).
Current Out 1

Source Analyte 1
Full 1000.0
Zero 0.0
Type 4-20 mA
Over Range Disabled
HOME ALARMS STATUS SETUP
Check the Current Out 1 Source (species) , Full (full-scale), and Zero
(zero point) settings/values and compare them to the settings/val-
ues listed on the analyzer documentation shipped with the ana-
lyzer to ensure they correspond.
b. Check the other outputs , comparing their settings/values to their
corresponding settings/values listed on the analyzer documenta-
tion.
If any of the settings need to be changed, refer to “Current Output
Setup Screens” in Chapter 4 for details.
8. View the relay settings. To do this:
a. Press the
SETUP
soft key to view the SETUP menu screen. Scroll
down to select Relays and press
ENTER
to display the Relay
screen. Scroll down to select Relay 1 and press
ENTER
to display
the Relay 1 screen (Figure 3-7).
Figure 3-7.
Relay Setup screen
(Relay 1).

Relay 1

Function Enable
Source None
Value 0
Delay 0 Sec
HOME ALARMS STATUS SETUP
Check the Relay 1 Function (operational status setting for this
relay), Source (species) , Value , and Delay (zero point) settings/val-
ues and compare them to the settings/values listed on the analyzer
documentation shipped with the analyzer to ensure they corre-
spond.