Ametek IPS-4-UV, Руководство пользователя

Страница: 103 / 200

Controller / User Interface | 4-37
e. Enter the IP Address , IP Subnet Mask address, and Gateway IP
address (optional), pressing
ENTER
after entering each address.
f. Ensure the DHCP server is on the same server as the analyzer.
g. Press
CANCEL
to back out of this sub-menu.
5. Reset the analyzer to allow the changes to take effect.
Refer to Page 31 Analyzer Reset instructions in Chapter 5
System Screen
The System screen (Figure 4-37) allows the user to view and/or set up
analyzer system parameters.
Model Name , Serial Number , and Software Version are not editable, as
indicated by the ‘ > ’ cursor.
System Time and System Date are editable, as indicated by the ‘

’ cursor.
To enter Edit mode for either of these parameters, press
ENTER
and then
press the appropriate numeric character. You can also use the
RIGHT
/
LEFT
arrow key to jump over a character. The cursor will jump over the colon
( : ) and slash ( / ) characters when entering the time and date.
Model Name
This displays the Analyzer Model name.
Serial Number
This displays the analyzer serial number.
Software Version
This displays the analyzer software version.
System Time
The System Time clock is used for time-stamping various analyzer
functions (such as alarms).
To set the time, use the
RIGHT
/
LEFT
arrow key to select hours , minutes ,
and seconds and then either the
UP
/
DOWN
arrow key or numeric keys
to enter the time. When using the numeric keys to enter a value (while
setting the time), the cursor (the active, editable character) will move
one character to the right and skip over the colon ( : ) character.
Figure 4-37.
System screen.
> Model Name IPS-4
Serial Number 12345678
Software Version 1.10
System Time

15:22:29

System Date

07/11/2005
HOME ALARMS STATUS SETUP