AMAZONEN-Werke Amazone Centaya 3000 Super 1600, Руководство по эксплуатации

Страница: 28 / 222

General Safety Information
28
Centaya Super BAH0092-6 10.20
Implement transportation

When using public roads, national road traffic regulations must be observed.

Switch off the control terminal before road transport.

Before road transport, check

that the supply lines are connected correctly

the lighting system for damage, function and cleanliness

the brake and hydraulic system for visible damage

whether the tractor parking brake is completely released.

the function of the brake system.

Always ensure that the tractor has sufficient steering and braking power.
Any implements and front/rear weights connected to the tractor influence the driving behaviour
and the steering and braking power of the tractor.

If necessary, use front weights.
The tractor front axle must always be loaded with at least 20 % of the empty tractor weight to
ensure sufficient steering power.

Always properly fasten the front or rear weights to the intended fastening points.

Comply with the maximum payload of the mounted/towed implement and the permissible axle
and drawbar loads of the tractor.

The tractor must guarantee the prescribed brake delay for the loaded vehicle combination (tractor
plus mounted/towed implement).

Check the brake power before moving off.

When turning corners with the mounted or towed implement, take the wide sweep and centrifugal
mass of the implement into account.

Before transporting the implement, ensure sufficient side locking of the tractor lower links if the
implement is attached to the three-point hydraulic system or lower links of the tractor.

Before road transport, move all the swivel implement parts to the transport position.

Before road transport, secure all the swivel implement parts in the transport position against risky
position changes. Use the transport locks intended for this.

Before road transport, lock the operating lever of the tractor's three-point hydraulic system
against the unintentional raising or lowering of the mounted or towed implement.

Before road transport, check that the required transport equipment, e.g., lighting, warning
equipment and protective equipment, is correctly installed on the implement.

Before road transport, perform a visual check that the top and lower link pins are firmly fixed with
the linch pin against unintentional release.

Adjust your forward speed to the respective prevailing conditions.

Before driving downhill, switch to a lower gear.

Before road transport, always switch off the independent wheel braking (lock the pedals).

Observe the maximum permissible total weight.