Amazone Ceus 4000-2TX, Руководство по эксплуатации

Страница: 101 / 132

Faults
11 Faults
Fault Remedy
Different working depths across the working
width
•
Hydraulic depth setting: Synchronise the hydraulic
cylinders, see below.
•
Mechanical depth setting: Check that all of the
spindles have the same length.
•
Reduce the traction assistance
•
Check the coulters for wear
•
Check for correct working position:
ο
Operate the drawbar in float position.
ο
Completely retract the running gear.
ο
Completely unfold the booms.
Discs/tine rows clog with crop material.
•
Raise the implement and lower again.
•
Check/adjust the working depth of the tine array
and the levelling unit.
•
Set the maximum tilt on the disc arms
Uneven work pattern behind the roller
•
Check/adjust the setting of the levelling unit.
Build up of soil in front of the roller.
•
Raise the implement and lower again.
•
Reduce the working depth.
•
Lower the running gear far enough so that it can
carry part of the implement weight. Adjust using the
spacer elements on the running gear cylinder.
•
Swivel the spring clearers or blade system up
wards
Blockage of the tooth packer roller. Adjust the scraper.
The drawbar slopes down when the imple-
ment in uncoupled. Close the stop tap on the drawbar cylinder.
Shear bolts of the overload safety shear off
repeatedly. Check the tightening torques and bolt quality
Different working depths across the working width?
→
Synchronise the hydraulic cylinders!
For a uniform working depth across the entire implement width, the
corresponding hydraulic cylinders must have the same length.
If this is not the case, the hydraulic cylinders can be synchronised:
1. Keep actuating the green tractor control unit until the hydraulic
cylinders are completely extended.
2. Continue actuating the control unit for another 10 s.
→
An overflow process is initiated that flushes all of the cylinders.
This adjusts the cylinders to the same length.
This procedure should also be performed before operation after a
longer period of standstill.
Different working depths at the front and rear?
•
Synchronise the hydraulic cylinders (see above)
•
Mechanical depth adjustment: Check that all of the spindles
have the same length.
•
Align the implement horizontally.
Ceus-2TX BAG0183.2 01.19 101