Agrio Gigant, Инструкция по эксплуатации

Страница: 29 / 96

5. couple the isobus plug
to the ISOBUS socket of the tractor.
6. crank up the support foot / raise the hydraulic support foot.
7.
remove the wheel chocks
1. drive tractor to the machine
Attention!
When reversing the tractor to the sprayer, there must be nobody between the tractor and the
sprayer.
A helper may only steer the tractor and approach the sprayer when the tractor is at a standstill.
Secure the tractor against unintentional starting and moving off,
-
When connecting the sprayer and driving on roads and paths, observe the road traffic
regulations.
2.
Couple the machine behind the tractor with a jaw coupling or a ball coupling.
- Slowly drive the sprayer until the hinge engages.
3. connect brake lines
ATTENTION!
When connecting the brake and supply lines, make sure that:
- the sealing rings of the connection heads are clean,
- properly seal the sealing rings of the connection heads.
- Replace damaged sealing rings immediately.
- drain the air tank before the first ride of the day.
- You must not drive off with the connected machine until the pressure gauge of the tractor is
indicates a pressure of min. 5.0 bar!
Connection method
1) Attach the brake line coupling (yellow)
with the yellow coupling on the tractor.
2) Attach the connection head of the supply line (red)
into the red clutch of the tractor.
MAKE SURE YOU DON'T USE THE REVERSE PROCEDURE!!!