Agrio Gigant, Инструкция по эксплуатации

Страница: 61 / 96

14.2.1.1
Maintenance of the axes
14.2.1.1.1 Tightening and loosening wheel nuts
Checking the tightening torque of the wheel nuts.
After the first 10 km under full load, at each wheel change and every 500 operating hours and not
longer than one year.
Tighten the wheel nuts according to the table below using a torque wrench.
If you do not have a torque wrench, use a pipe wrench with socket. The penultimate column on
the right of the table shows the lever length corresponding to the required tightening torque,
calculated for a force of F = approx. 60 kg.
Wrench (mm) Number of nuts Tightening torque
(kgm)
Tightening torque
(Nm)
Lever
(mm)
Applied force (kg)
27 8 - M 20 x 1.5 35 min - 38 max 350 min - 380 max 600 60
30 10 - M 22 x 1.5 45 min - 51 max 450 min - 510 max 800 60
14.2.1.1.2 Checking the brake pads
The brake lining inspection must be carried out after 500 operating hours at the latest.
The inspection is carried out via the 2 inspection openings on the back of the brakes (see
illustration).
During inspection, open these two cutouts and check the thickness of the lining. If the lining
is approx. 2 mm from the reference line, the brake lining must be replaced.
Always use original brake pads of the same type. The characteristics of the pads are listed in
the reference line.