Agilent Technologies U1840A Medalist sj5000, Руководство по оборудованию

Страница: 40 / 192

3-2 Agilent U1840A Medalist sj5000 Hardware Manual
3
Installation
Checking the Facilities and Tools
Ensure that the system environment meets the specifications
(see
“Environmental Conditions” ). Refer to the Site
Preparation Manual for details.
Required Tools
The following tools are required for sj5000 installation:
• Set of metric hexagonal Allen keys: 1.5, 2, 2.5, 3, 4, 4.5, 5, 5.5,
6, 7, 8, 9, and 10
• T30 TORX key
• Set of insulated slotted screwdrivers: 2.8, 4.0, 5.5, and 6.5
• Pistol grease gun
• THK AFB+70 (lithium based) grease
• 25 mm/46 mm spanner
Unpacking the sj5000
The sj5000 is shipped on a wooden pallet with a cardboard box
enclosing the system.
Unpack the sj5000 as follows:
1
Check all the Tip’n’tell indicators and shock sensors.
Figure 3-1 shows their locations on the box. Refer to the
details on the indicators to verify pass or failure.
If any of them are activated, the sj5000 may have a problem.
Do not remove anything and report the situation to Agilent.
2
Remove the straps holding the cardboard box in place.
3
Remove the cardboard edge protectors.
4
Remove the top of the cardboard box, and lift the remainder
of the box away from the wooden pallet.
5
Undo the ratchet straps that hold the sj5000 to the wooden
pallet.
The sj5000 can now be lifted off the pallet using a forklift and
moved into position. See
“Moving the sj5000” for important
notes and instructions.