Agilent Technologies U1840A Medalist sj5000, Руководство по оборудованию

Страница: 129 / 192

Setting Up Barcode Readers
10
Agilent U1840A Medalist sj5000 Hardware Manual 10-13
This will download the setup file to the barcode reader. The
reader will emit a beep to indicate the download was
successful.
8
Remove the barcode reader from the XP-40 port and replace
with the slave barcode reader.
9
Click
Auto connect
to communicate with the barcode reader.
10
Click
File
>
Open
to open the setup file 820DL01.esp.
11
Click
Send/Recv
>
Send to Reader
>
Send and Save
to save this
to slave barcode reader.
12
Plug the master barcode reader to the XP-40 port and the
slave barcode reader to the XP-41 port on the breakout box.
13
To test both barcode readers, click
Terminal
.
a
Click
Enable Serial Trigger
>
Send Trigger Character
.
(Alternatively, trigger the conveyor entry sensor.)
b
Scan a barcode with the master barcode reader and the
decoded barcode text should be displayed with a 00
prefix.
c
Scan a barcode with the slave barcode reader and the
decoded barcode text should be displayed with a 01
prefix. Note that it will be displayed only when the master
barcode reader times out.
14
Close the ESP software and launch the sj5000 software.