4 Setting up the BenchCel device
Setup workflow
64
BenchCel Microplate Handler User Guide
Setup workflow
About this topic
This topic presents the workflow for setting up the BenchCel Microplate Handler for
operation.
Before you start
Before setting up the BenchCel Microplate Handler, you should already have definitions
for the labware you want to use. For instructions on how to define labware in the
VWorks software, see the
VWorks Automation Control Setup Guide
.
Before setting teachpoints (step 7 in the setup workflow), you should also adjust the
BenchCel sensor thresholds for each type of labware that you use. For details, see
“Setting sensor thresholds” on page 99
.
Workflow
The following table presents the steps for setting up the BenchCel Microplate Handler.
After setting up the BenchCel Microplate Handler for the first time, you will not likely
change any of the settings in the procedure unless you add a device, replace a device, or
move the BenchCel Microplate Handler.
