ADCMT 4601 I-V Meter, Руководство по эксплуатации

Страница: 52 / 236

4601 I-V Meter Operation Manual
2.3 Rear Panel
2-12
GPIB connector Used to remotely control the 4601 by GPIB.
Temperature measurement connector Tc1, Pt1, Ad1
5-pin connector for Ch1 to connect the miniature thermocouple socket that
connects the T-type thermocouple, the PT sensor and IC sensor (AD590)
(Refer to 5.1.4, "Temperature Measurement Terminal")
For more information on the IC sensor (AD590), refer to the data sheet of
Analog Devices, Inc.
Contact signal input and output CONTACT IN/OUT
15-pin Dsub connector for contact signals that are used to control shutter
opening and closing of a solar simulator (Output: 4 bits and input: 2 bits)
(Refer to Section 5.5.1, "Contact Signal Input and Output")
Temperature measurement connector Tc1, Pt2, Ad2
5-pin connector for Ch2 to connect the miniature thermocouple socket that
connects the T-type thermocouple, the PT sensor and IC sensor (AD590)
(Refer to 5.1.4, "Temperature Measurement Terminal")
For more information on the IC sensor (AD590), refer to the data sheet of
Analog Devices, Inc.
OPERATE IN/OUT BNC connector for input and output signals to synchronize the output ON
or OFF of multiple devices (Refer to Section 5.5.2, "External Control Sig-
nals)
COMPLETE OUT SYNC OUT
BNC connector to output measurement end, sweep end and step
synchronous signals (Refer to Section 5.5.2, "External Control Signals)
TRIGGER IN BNC connector to input measurement start and sweep start signals
(Refer to Section 5.5.2, "External Control Signals)
No display Input and output connector for maintenance
9
10
11
12
13
14
15
16