ADCMT 4601 I-V Meter, Руководство по эксплуатации

Страница: 175 / 236

4601 I-V Meter Operation Manual
6.6.3 Remote Command List
6-29
Mea-
sure-
ment Integration time IT0 5

s
IT1 10

s
IT2 25

s
IT3 50

s
IT4 100

s
IT5 250

s
IT6 500

s
IT7 1 ms
IT8 2.5 ms
IT9 5 ms
IT10 10 ms
IT11 1 PLC
IT12 2 PLC
IT13 100 ms
IT14 200 ms
IT? Response: IT0 to IT14
Spot measure-
ment
integration time SIT7 1 ms
SIT8 2.5 ms
SIT9 5 ms
SIT10 10 ms
SIT11 1 PLC
SIT12 2 PLC
SIT13 100 ms
SIT14 200 ms
SIT? Response: SIT7 to SIT14
Spot measure-
ment
execution SPM?1 Vm Executes the specified function measurement
and returns the measured value.
SPM?2 Im rng: 1 to 3 (can be omitted) For more
information, refer to the R command of the
measurement range setting
SPM?3 [,rng] Ir SPM?1: ADC1 Vm measurement
SPM?4 [,rng] Em SPM?2: ADC2 Im measurement
SPM?5 Tc1 SPM?3 to SPM?10: ADC3 specifying
function measurement
SPM?6 Pt1 or Ad1
SPM?8 Tc2 The response is output in the format
described in Section “6.5.4 ASCII Output
Format.”
SPM?9 Pt2 or Ad2 However, the header is always output in the
ASCII format.
NOTE: Not executable in the DC source mode.
Measurement
buffer
memory ST0 Store OFF *8
ST1 ON
ST? Response: ST0 or ST1
RL Initializes the stored data.
RN n[,adr] n: 0... Releases recall execution status.
*5
1... Sets recall execution status.
adr: Recall data number (0 to 3999)
(The data number is not changed if this
setting is omitted.)
Reading out the recall data by using the talker
function after the recall execution status is set
performs the following operation.
• Increments the recall data number after
the data output.
• If data does not exist in the specified
number, the output
becomes <EE +8.30>.
• Reading out does not erase the data in
memory.
*5: Not initialized by the RINI command.
*8: It is set to OFF when switching to the DC mode, and set to ON when switching to the sweep mode.
It cannot be set to OFF in the sweep mode.
Item Command Description
Default Operation
During
calibration
Power
ON
Factory
shipment
DC
OPR/SUS
Sweep
OPR/SUS