ABB XT7, Руководство по эксплуатации и обслуживанию

Страница: 167 / 193

ABB | SACE Tmax XT
External electronic accessories | 9 - Ekip Link 165 | © 2020 ABB | 1SDH001821A1002 - ECN000135670
Continued from the previous page
Parameter Description Default
Disable Gratuitous ARP
Permits (Enabled ARP) the periodic generation of a Gratuituos
ARP message, used by Ekip Connect to rapidly find the
modules via Ethernet scan without knowing the IP address
beforehand
ARP Enabled
Password protected
access Enables the writing operations performed via the network to be
protected by a password (Request password) Standard
mode
Password Modbus TCP
With access protected by enabled password, this is the
password to use before each writing session
(2)
.
Local access
(1)
Enable IEEE 1588 and Enable SNTP client must not be enabled at the same time
(2)
the parameter can only be changed via system bus in the remote configuration
Remote Link configurations Regarding the Link functions, the following further parameters are available:
Parameter Description Default
Link Actor (1÷15) IP address of each actor (from 1 to 15) 0.0.0.0
Remote Programmable
Status (A÷D)
Configuration parameters of the configurable states:
• selection of actor (actor from 1 to 15) which activates the
programmable status
• event of the actor that determines change of programmable
status
Actor 1
None
Remote Status word
(A÷D)
Configuration parameters of the words:
• selection of actor (actor from 1 to 15) from which the word
status is taken
• selection of the taken word
None
1 global
Diagnostic
Active (Passive diagnosis) or deactivated (No diagnosis) cabled
selectivity diagnosis
No Diagnostic
Diagnostic check timeout
30 s, 1 min, 10 min, 60 min diagnosis frequency intervals
available, if activated
30 seconds
Zone Selectivity Type
Configuration of hardware selectivity (Only HW) or hardware
and logic (Mixed)
HW only
Repeat Configuration
mask Interactive mask for selecting selectivity to be sent also to the
upper levels (even if not active in the programmed device)
0x0000
Remote information
Additional information can be accessed via the service connector (via Ekip Connect) or via a system bus
communication:
Information Description
HW and Boot version
General module information
Flash CRC status and
result
Information about the correctness of the SW in the module
Ekip Link status
Signals Ethernet cable connection errors
SNTP Server Error Error in communication with SNTP server
SNTP Server
Synchronization
State of synchronism with SNTP server
IEEE 1558 status
Valid with Master IEEE 1588= ON , notifies the presence (Slave or PTP Master
Active) or absence (PTP Master but Passive) of a higher level master
Remote Link information Regarding the Link functions, the following further parameters are available:
Information Description
Line Congruency detection
Information about the state and inconsistency of HW and logic
selectivity (state and type of selectivity inconsistent)
Remote Programmable Status
Status (true/false) of remote programmable statuses A, B, C and D
Remote Status Word Value of remote programmable Words A, B, C, D
Logic Zone Selectivity Logic selectivity states (inputs and outputs)