ABB XT7, Руководство по эксплуатации и обслуживанию

Страница: 129 / 193

ABB | SACE Tmax XT
Ekip Touch - Settings | 1 - Main settings 127 | © 2020 ABB | 1SDH001821A1002 - ECN000135670
Bluetooth Low Energy -
Parameters
The following parameters are available
Parameter Description Default
Enable
Enables/disables Bluetooth Low Energy antenna switch-on and
availability of the other parameters in the menu:
• if
On , the antenna comes on, on the basis of the Battery Mode
parameter configuration
• if
Off , the antenna is off
Off
Battery mode
Defines the switch-on mode of the Bluetooth Low Energy
antenna, based on the presence of the devices on the service
connector (Ekip T&P, Ekip Programming, Ekip TT); can have two
values:
• --- ; with this option, the state of the antenna depends
esclusively on the presence of devices: on if not present; off if
present
•
ON ; with this option, the antenna is switched off for 15
seconds when a device is connected, after which: it remains off if
communication with the device has been activated; it comes on if
no communication has been activated
IMPORTANT: the typical scenario in which Battery
mode should be configured = On is: Ekip Touch + Ekip
TT + communication with smartphone activated; in all
other cases, including System Update, configure
Battery mode = ---
---
Start Pairing
Command which starts Pairing between Trip unit and external
device. To perform the operation correctly:
1. Press Connect on EPiC APP, select the Trip Unit from among
the units in the list and then select Connect again
2. Press Start Pairing in the Trip unit menu, enter the PIN, then
press Start Pairing again
3. Press Start Pairing on EPiC APP and confirm the operations
until the code request appears
4. Check that the pop up with the Passkey appears on the display
of the Trip unit (about 20 seconds) and enter it in EPiC APP
5. The Trip unit will be connected to the external device from this
moment on; for the successive re-connections, it will be sufficient
to just repeat point 1
NOTES:
• execute the procedure within 120 seconds
• the command is not available if communication with a
device is activated
---
Decouple devices
Command that deletes the list of devices coupled to the Trip unit
NOTE: the command is not available if communication with
a device is activated
---
Version
FW version of the Bluetooth Low Energy module installed on
board
---
IMPORTANT: when Bluetooth Low Energy antenna is on, communication on the
service connector is not available
IMPORTANT: if Bluetooth is disabled during the order (with the extracode) or disabled
by a Service L3 authorized person, the dedicated menu will neither be present,
nor visible nor usable. The icons will not be shown on the screen if Bluetooth is
disabled