ABB IRB 1100, Руководство по эксплуатации продукта

Страница: 98 / 766

4.3 Cleaning activities
4.3.1 Cleaning the IRB 1100
General
To secure high uptime it is important that the IRB 1100 is cleaned regularly. The
frequency of cleaning depends on the environment in which the manipulator works.
Different cleaning methods are allowed depending on the type of protection of the
IRB 1100.
Note
Always verify the protection type of the robot before cleaning.
WARNING
Turn off all electrical power supplies to the robot before starting the cleaning.
Special cleaning considerations
This section specifies some special considerations when cleaning the robot.
• Always use cleaning equipment as specified. Any other cleaning equipment
may shorten the life of the robot.
• Always check that all protective covers are fitted to the robot before cleaning.
• Do not point the water jet at connectors, joints, sealings or gaskets.
• Do not use compressed air to clean the robot.
• Do not use solvents that are not approved by ABB to clean the robot.
• Do not spray from a distance closer than 0.4 m.
• Do not remove any covers or other protective devices before cleaning the
robot.
Cleaning methods
This following table defines what cleaning methods are allowed for ABB
manipulators depending on the protection type.
Cleaning method Protection
type
High pressure water,
steam or spray Rinse with water Wipe with cloth Vacuum
cleaner
No No Yes. With light
cleaning deter-
gent. Yes Standard
IP40
No Yes. It is highly re-
commended that
the water contains
a rust-prevention
solution and that
the manipulator is
dried afterwards. Yes. With light
cleaning deter-
gent. Yes IP67 (option)
Continues on next page
98 Product manual - IRB 1100
3HAC064992-001 Revision: L
© Copyright 2019-2022 ABB. All rights reserved.
4 Maintenance
4.3.1 Cleaning the IRB 1100