3Com 5500-EI PWR, Справочное руководство

Страница: 37 / 1314

1-28
Use the undo user privilege level command to revert to the default command level.
By default, the commands at level 3 are available to the users logging in to the AUX user interface. The
commands at level 0 are available to the users logging in to VTY user interfaces.
Commands fall into four command levels: visit, monitor, system, and manage, which are described as
follows:
z
Visit level: Commands at this level are used to diagnose network, such as the ping , tracert , and
telnet command. Commands at this level cannot be saved in configuration files.
z
Monitor level: Commands at this level are used to maintain the system, to debug service problems,
and so on. The display and debugging commands are at monitor level. Commands at this level
cannot be saved in configuration files.
z
System level: Commands at this level are used to configure services. Commands concerning
routing and network layers are at system level. You can utilize network services by using these
commands.
z
Manage level: Commands at this level are for the operation of the entire system and the system
supporting modules. Services are supported by these commands. Commands concerning file
system, file transfer protocol (FTP), trivial file transfer protocol (TFTP), downloading using
XModem, user management, and level setting are at administration level.
Refer to CLI Configuration for information about command level.
Examples
# Configure that commands at level 1 are available to the users logging in to VTY 0.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] user-interface vty 0
[Sysname-ui-vty0] user privilege level 1
# You can verify the above configuration by Telnetting to VTY 0 and displaying the available commands,
as listed in the following.
<Sysname> ?
User view commands:
cluster Run cluster command
debugging Enable system debugging functions
display Display current system information
mtracert Trace route to multicast source
nslookup Query Internet name servers
ping Ping function
quit Exit from current command view
reset Reset operation
send Send information to other user terminal interfaces
super Set the current user priority level
telnet Establish one TELNET connection
terminal Set the terminal line characteristics
tracert Trace route function
undo Cancel current setting