3Com 5500-EI PWR, Справочное руководство

Страница: 347 / 1314

4-33
By default, the number of OSPF ECMP routes is 3.
Examples
# Set the number of OSPF ECMP routes to 2.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] ospf 1
[Sysname-ospf-1] multi-path-number 2
network
Syntax
network ip-address wildcard-mask
undo network ip-address wildcard-mask
View
OSPF area view
Parameters
ip-address:
IP address of the network segment where the interface resides, in dotted decimal notation.
wildcard-mask:
Wildcard mask, in dotted decimal notation. The wildcard mask is the exact reverse, bit
for bit, of the subnet mask. For example, if the subnet mask is 255.0.0.0, the wildcard mask is
0.255.255.255.
Description
Use the
network
command to enable an interface to run the OSPF protocol.
Use the
undo network
command to disable an interface from running OSPF.
By default, the interface does not belong to any area.
To run OSPF on an interface, the master IP address of this interface must be in the range of the network
segment specified by this command. If only the slave IP address of the interface is in the range of the
network segment specified by this command, this interface will not run OSPF.
Related commands:
ospf
.
Examples
# Specify the interfaces whose master IP addresses are in the segment range of 10.110.36.0/24 to run
OSPF and specify the number of the OSPF area (where these interfaces reside) as 6.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] ospf 1
[Sysname-ospf-1] area 6
[Sysname-ospf-1-area-0.0.0.6] network 10.110.36.0 0.0.0.255