3Com 5500-EI PWR, Справочное руководство

Страница: 1250 / 1314

1-20
lldp hold-multiplier
Syntax
lldp hold-multiplier value
undo lldp hold-multiplier
View
System view
Parameters
value : TTL multiplier, in the range 2 to 10.
Description
Use the lldp hold-multiplier command to set the TTL multiplier.
Use the undo lldp hold-multiplier command to restore the default.
The TTL multiplier defaults to 4.
You can set the TTL of the local device information by configuring the TTL multiplier.
The TTL of the information about a device is determined by the following expression:
TTL multiplier × LLDPDU sending interval
You can set the TTL of the local device information by configuring the TTL multiplier. Note that the TTL
can be up to 65535 seconds. TTLs longer than it will be rounded off to 65535 seconds.
To enable local device information to be updated on neighboring devices before being aged out, make
sure the interval to send LLDPDUs is shorter than the TTL of the local device information.
Examples
# Set the TTL multiplier to 6.
<Sysname> system-view
[Sysname] lldp hold-multiplier 6
lldp management-address-tlv
Syntax
lldp management-address-tlv [ ip-address ]
undo lldp management-address-tlv
View
Ethernet interface view
Parameters
ip-address : Management address to be set.
Description
Use the lldp management-address-tlv command to enable the management address sending. This
command also sets the management address.