ZyXEL Communications OMC-2301, User Manual

Page: 168 / 224

Chapter 19 Introducing the Commands
OMC-2301 User’s Guide
168
19.10.7 epon-profile Commands
The following table lists the
epon-profile
commands in configuration mode. Use these
commands to configure general PON port settings.
port-based-vlan
port <1-4>
forward <port-
list>
Removes the outgoing port(s) for
traffic from the specified port.
port-based-vlan
port <1-4> pvid
Removes the specified port’s VLAN
ID.
up-queue
Disables upstream priority queuing.
onu-phy port <1-4> auto-negotiation
Sets the device to establish the
connection to the specified port on the
ONU using auto-negotiation for the
link speed and duplex mode.
duplex
<half|full>
Sets the duplex mode to the specified
port on the ONU.
flow-control
Enables flow control for the
connection to the specified port on the
ONU.
power-down
Disables the connection to the
specified port on the ONU.
speed <10|100>
Sets the connection speed to the
specified port on the ONU.
port-based-vlan
Enables port-based VLAN on the
ONU.
port <1-4>
forward <port-
list>
Sets the outgoing port(s) for traffic
from the specified port.
port <1-4> pvid
<1-4094>
Sets the specified port’s VLAN ID.
up-queue
Enables upstream priority queuing.
queue <0-3> size
<0-960>
Sets the queue size.
Table 53 epon-onu4-profile Commands (continued)
COMMAND DESCRIPTION
Table 54 epon-profile Commands
COMMAND DESCRIPTION
epon-profile
<name>
Sets a descriptive name for the profile
and enters the epon-profile mode.
active
Enables this profile.
address-learning
Enables MAC address learning for this
profile.
address-limit <0-64>
Sets the number of MAC address
allowed.