Operating the ECU
1.
Install the EISA add-in boards into your system.
2.
Power on the system as described in the Setting Up Guide.
3.
Access Setup and enable the onboard floppy disk controller,
specify the correct type of floppy disk drive, enable or disable
console redirection to the COM ports, and enable the floppy
disk drive if it is disabled. If you are using console
redirection, edit the CONFIG.SYS file on the ECU floppy
disk to add /M and /B parameters to the end of the line that
begins “shell=”. Refer to the :Command Line Parameters"
section in this chapter for additional information.
3.
Start the ECU by inserting the system configuration disk
into floppy disk drive A and reboot the system.
4.
Follow the ECU main menu prompts. To select an item from
the menu, use
and
⊕
to highlight the item and press
ENTER. If you are using a mouse, point to an item and then
double-click the left button to select it.
5.
Select “Learn about configuring your computer” from the
ECU main menu if you need more information.
6.
Select “Access System Utilities” to configure passwords,
system speed, speaker, and cache options, or select
“Configure computer” to view a submenu.
7.
Select “View and edit” and follow the steps on the screen.
Note: Press the F1 key at any time for help and additional
information on each option.
Note: Refer to the table at the end of this chapter to record your
ECU settings.
04/APRIL/93 – 595-5484-UU
32
3-10
Configuring Your System
