Configuring Your System
There are three ways to configure your system, through the ECU
stored on floppy disk, through the Setup utility stored in flash
memory (non-volatile memory that is easily changed)., or by
changing jumper positions on the system board.
If your system has been factory configured, the ECU (EISA
configuration utility) and the Setup utility may not need to be
run unless you change the password or security features, add
adapter boards, or upgrade your system.
Note: Since the configuration information stored in the ECU
overrides the configuration information stored in the Setup
utility. It is strongly recommended that you only use the Setup
utility for the following two reasons:
1.
If the floppy disk drive is disabled and you want to enable
the floppy disk drive to access the ECU.
2.
To disable the floppy drive after changing the ECU to stop
unauthorized ECU changes.
04/APRIL/93 – 595-5484-UU
23
3-1
Configuring Your System
