ZENER 8000-V Installation Manual
IM00165
29
Local Mode Operation Example
The Speed / Reference display above shows the desired output speed is 40 Hz and the motor is rotating at 25 Hz
in the forward direction in local mode as indicated by the status “
FWD LOC
”. Some notes:
The ZENER 8000-V was started by pressing the
▲
FWD button.
The speed reference is increased by pressing the
▲
FWD button. The motor will accelerate to this
speed.
The speed reference is decreased by pressing the
▼
REV button. The motor will decelerate to this
speed.
The ZENER 8000-V may be started in reverse by pressing
▼
REV button.
Pressing STOP will stop the motor or reset any trip condition.
Press ESC to access the configuration menus
IMPORTANT!
If the motor shaft rotates in the wrong direction remove the input power, wait for the
ZENER 8000-V to discharge and swap any two motor phase wires. Re-apply input power and select a
direction by pressing
▲
FWD or
▼
REV.
