ZENER 8000-V Installation Manual
_
2
IM00165
Do not modify this equipment electrically, mechanically or otherwise. Modification may create
safety hazards.
The ZENER 8000-V is designed to drive an appropriately rated and otherwise suitable 3 phase
induction motor. It is not suitable for single phase motors or other types of motor or non-motor
load. Use with inappropriate load types may create a safety hazard.
Where the ZENER 8000-V is used as a component part of another product, it is the purchaser’s
responsibility to ensure that the final product meets all of the necessary safety, EMC,
regulatory, operational and other requirements for that product. Requirements for the
purchaser’s final product may be substantially different to the requirements for stand-alone
inverters.
The ZENER 8000-V is manufactured under strict quality control arrangements, however
additional and independent safety equipment must be installed if the application is such that
failure of the product may result in personal injury or property damage.
Ensure that electrical noise generated by the product and any associated equipment does not
adversely affect the proper operation of other equipment or systems, particularly those that
have a safety function.
Install emergency stop circuitry that removes power from the ZENER 8000-V and does not
depend on any feature of the product for proper and safe operation. Do not use the braking
functions of the product for safety purposes.
The ZENER 8000-V has features that may be used to cause an automatic restart in certain
circumstances. The overall application (machine etc) must be designed such that automatic
restart is not hazardous.
Do not install this equipment in locations where mechanical damage to the enclosure is
possible. In particular, consider vehicles, vandalism and attack by insects or animals. Severe
equipment damage and safety hazards may result.
Receiving
Inspect the ZENER 8000-V for any shipping damage. If any damage is found, report it to the carrier immediately.
Do not attempt to operate the ZENER 8000-V if any obvious damage exists.
After the initial inspection, the ZENER 8000-V can be repacked and stored in a clean, dry location until it is
required for use.
DO NOT store this equipment in an area where the ambient temperature will fall below -20°C or rise above
70°C. DO NOT store this equipment in areas that are subject to condensation or corrosive atmosphere. Proper
storage is necessary to ensure satisfactory controller start up and performance.
Software
This manual applies to ZENER 8000-V software revision 5.2.x. The software revision is displayed briefly at power
up and may also be viewed in the service menu.
i
This manual provides basic control configuration information for the ZENER 8000-V to suit
more common applications. Please refer to the
ZENER 8000-V Reference Manual IM00140
for
a detailed explanation of each control feature, including communications protocols.
